Service Information:
                     The following table contains the microprocessor upgrade jumper positions for ValuePoint 6382/S, 6387/T, and 6384/D (except P60)
                     systems.


                                                System Board
                     Installed                  Type 1       Type 2
                     Processor(s)               J10  J11     J17  J18

                     ------------------------------------------ ------------------------------------------------

                     80486SX only                R    R       R    R
                     80486SX & 80487SX           R    R       R    R
                     80486SX & OVERDRIVE         R    R       R    R
                     80486SX & DX                F    F       F    F
                     80486DX only                F    X       F    X
                     80486DX2 only               F    X       F    X
                     OVERDRIVE only              R    R       R    R
                     80486SX & DX4 Overdrive (1) R    R       R    R
                     DX4 OVERDRIVE only (1)      R    R       R    R

                     -------------------------------------------------------------------------------------------------------------
                     R = Rear two pins (labeled OD and closest to I/O connectors)
                     F = Front two pins
                     X = Front or rear two pins


                     Microprocessors can be identified by the following characteristics: 
                     80486SX - Soldered to system board; no heat sink
                     80487SX - Intel 80487 printed on heat sink
                     80486DX* - Heat sink without identification
                     80486DX2* - Heat sink without identification
                     IBM Overdrive - "IBM FRU P/N92F2582" printed on heat sink
                     Intel Overdrive - "Intel Overdrive" printed on heat sink
                     Intel DX4 Overdrive (1) - "Intel DX4 Overdrive" printed on heat sink and an attached voltage regulator board.

                     Notes:
                     The IBM PCCO has not tested the Intel DX4 Overdrive on these models. If problems are suspected with the DX4, refer
                     customer to the point of purchase or Intel support.

                     Use the system Configuration Utility to differentiate the DX and DX2 processors.

                     Intel is a trademark of Intel Corporation.

                     SAS KEYWORDS:                                                        
                     PSVP               PS/VP              VALUEPOINT         6382     
                     6384               D/T6382            PSVPBRD            PSY2BRD  
                     OVER DRIVE         D/T6387            6387               DX/4