From: Digest To: "OS/2GenAu Digest" Date: Thu, 24 Jun 2004 00:01:08 EST-10EDT,10,-1,0,7200,3,-1,0,7200,3600 Subject: [os2genau_digest] No. 874 Reply-To: X-List-Unsubscribe: www.os2site.com/list/ ************************************************** Wednesday 23 June 2004 Number 874 ************************************************** Subjects for today 1 Following on from the os2 SIG meeting : Robert Traynor (BobT)" **= Email 1 ==========================** Date: Wed, 23 Jun 2004 11:55:06 +1000 From: "Robert Traynor (BobT)" Subject: Following on from the os2 SIG meeting Hi All, Following on from the Melbourne os2 SIG meeting last night. Here is the URLs concerning the discussion and succesful demo install of Audio/Data-CD-Creator and CDRecord/2 for os/2. ----------------------------------------------------------------- Brief Quote:- The objective of these pages is to provide everything necessary for writing CDs with OS/2. Here's also a new home of CDRecord/2, Audio/Data-CD-Creator and the other programs written or ported by me. The pages are under construction so there may be dead links. You may have a look at my homepage on Geocities:- Enjoy! Chris Wohlgemuth ------------------------------------------------------------------ This file has most of the files needed to install Cdrecord etc and is about 4.3 mb in size (only missing EMX as most should have this already):- TIP:- If you already have the DaniAtapi drivers installed, make sure they are the latest version and also be aware that you MAY not require ANY parameters on the DaniAtapi.FLT line of your config.sys. TIP 2: If you use the automatic install for the ASPI drivers. Be aware that the file ?:\os2\boot\OS2ASPI.DMD may be back leveled. Make a backup copy first, install Aspi Router and then check and restore your backup file if needed. Reboot and then install the Cdrecord package. Here is the relevant (to CdRecord/2) lines of my config.sys with all the non relevant bits removed except for a few which should show their relative position. DEVICE=D:\OS2\BOOT\OS2CDROM.DMD rem DEVICE=D:\OS2\BOOT\jjscdrom.dmd substitute jjscdrom.dmd for OS2CDROM.DMD if you also have RSJ installed BASEDEV=DANIS506.ADD Dani IDE driver for hard disks BASEDEV=OS2DASD.DMD eCS standard driver not in Warp4 BASEDEV=OS2LVM.DMD eCS standard driver not in Warp4 BASEDEV=OS2SCSI.DMD standard scsi support driver BASEDEV=AICU160.ADD my scsi card driver. BASEDEV=DANIATAP.FLT /EJ /v Dani Atapi driver BASEDEV=OS2ASPI.DMD /ALL DEVICE=D:\OS2\BOOT\ASPIROUT.SYS Aspi driver Hope this helps, Regards, Robert Traynor (BobT). 23 June 2004 11:53 ,-._|\ Robert Traynor (BobT) / Oz \ email rtraynor at removeme.optusnet dot com dot au \_,--.x/ ----------------------------------------------------------------------------------