Now that you have configured the server, you are ready to install a DB2
client. Go to Chapter 26. "Installing DB2 Clients" for more information.
To access a remote server through Named Pipes, you must first have installed and configured communication software for both the client and DB2 Connect server workstations. See "Software Requirements" for the communication protocol requirements for your platform. See "Possible Client-to-DB2 Connect Gateway Connectivity Scenarios" for the supported communication protocols for your particular client and server.
If you have read and completed the instructions in "Setting the DB2COMM Registry Value", there are no further steps required to set up Named Pipe communications on
the server or to support the Administration Server.
|
|
Now that you have configured the server, you are ready to install a DB2
client. Go to Chapter 26. "Installing DB2 Clients" for more information.
|